GE JKP70BMBB Installation Instructions Manual

Also see for JTP70: Installation instructions Installation instructions Owner's manual Brochure Installation instructions

Contents

GE JKP70BMBB Installation Instructions Manual Manual pdf 8 page image

8NOTE: The middle rail separating the twoopenings may need to be larger than the 3”(7.6 cm) minimum shown. Always refer to theindividual installation instructions packed witheach product for specific requirements.Combined Advantium or MicrowaveOven and Wall Oven Installation:When installed in combination with asingle wall oven, use separate electricaljunction boxes.• Refer to the Advantium or microwaveoven installation instructions for electricalrequirements of that product.• These connections must be madeby a qualified electrician. All electricalconnections must meet National ElectricalCode or prevailing local codes.NOTE: Additional clearances may berequired. Check to be sure the ovensupports above the Warming Drawerdo not obstruct the required interior depthand height. The middle rail separating theopenings may need to be larger than the 2”(5.1 cm) minimum shown. Always refer tothe individual installation instructions packedwith each product for specific requirements.Warming Drawer Combined withAdvantium or Microwave Oven andSingle Oven:Install a separate 120V, 60Hz, properlygrounded receptacle. See installationinstructions packed with each productfor specific requirements.Note: Install theoven only withspecific modelslisted on the labellocated on top ofthe oven.CabinetrySingle 27″ (68.6 cm) OvenBelow an Advantium orMicrowave OvenSingle 27″ (68.6 cm) OvenBetween an Advantium orMicrowave Oven and aWarming Drawer2” (5.1 cm) Min.Per Advantium orMicrowave OvenRequirementCutout for 27″ (68.6 cm) Single Ovens only –Below an Advantium or Microwave Ovenor Between an Advantium or MicrowaveOven and a Warming DrawerFor JKS10, JKP30, JKP70, PK916, ZEK938 models only.A2” (5.1 cm) Min.2” (5.1 cm) Min.Per Advantium orMicrowave OvenRequirementPer WarmingDrawerRequirement