GE JKP70BMBB Installation Instructions Manual

Also see for JTP70: Installation instructions Installation instructions Owner's manual Brochure Installation instructions

Contents

GE JKP70BMBB Installation Instructions Manual Manual pdf 7 page image

7CabinetryNOTE: Additional clearances between cutoutsmay be required. Check to be sure the ovensupports above the Warming Drawer locationdo not obstruct the required interior depth andheight.• When installing a Warming Drawer belowa single or double oven, a separate 120V,60 Hz, properly grounded receptacle mustbe installed. Refer to installation instructionspacked with the Warming Drawer forspecific installation requirements.NOTE: Install theoven only withspecific modelslisted on the labellocated on top ofthe oven.Cutout for 27″ (68.6 cm) Single orDouble Built-In Ovens only – Over aWarming DrawerFor JKS10, JKP30, JKP35, JKP55, JKP70, JKP75, PK916, PK956, ZEK938,ZEK958 models only.ASingle 27″ (68.6 cm)Oven Overa Warming DrawerDouble 27″ (68.6 cm)Oven Overa Warming DrawerAnti-Tip BlockAgainst RearWall PerWarmingDrawerRequirement2” (5.1 cm)Min.1” (2.5 cm) Min. Above ToekickPer WarmingDrawerRequirementAnti-Tip Block AgainstRear Wall Per WarmingDrawer Requirement2” (5.1 cm)Min.1” (2.5 cm) Min. Above Toekick orAdjust to Oven Installation HeightPerWarmingDrawerRequirement