GE JKP70BMBB Installation Instructions Manual

Also see for JTP70: Installation instructions Installation instructions Owner's manual Brochure Installation instructions

Contents

GE JKP70BMBB Installation Instructions Manual Manual pdf 1 page image

1Built-In Wall OvenInstallationInstructionsBefore You BeginRead these instructions carefully and completely.• IMPORTANT—Save theseinstructions for local inspector’s use.• IMPORTANT—Observe allgoverning codes and ordinances.• Note to Installer—Be sure to leave theseinstructions with the consumer.• Note to Consumer—Keep theseinstructions for future reference.• Proper installation is the responsibilityof the installer and product failure dueto improper installation is NOT coveredunder warranty.• NOTE—This appliance must be properlygrounded.• ATTENTION INSTALLERAll electric wall ovens must be hard wired(direct wired) into an approved junctionbox. A plug and receptacle is NOT permittedon these products.Tools Needed1/8” (3 mm) Drill Bit andElectric or Hand DrillPhillipsScrewdriverMaterials NeededStrain Relief Clampfor 1/2” conduitJunctionBoxWire Nuts36” (91 cm)of String31-10647-1 03-07 JRParts Included(Appearance will vary)Screws For Installation(8-18 x .750 flat headPhillips wood screws)Optional 27″(68.6 cm)Metal BottomTrim Assembly(on some models orcan be purchasedseparately)27” (68.6 cm) modelsJKS10, JKP30, JKP35, JKP55, JKP70, JKP75,PK916, PK956, ZEK938, ZEK95830” (76.2 cm) modelsJTP30, JTP35, JTP55, JTP70, JTP75, PT916,PT920, PT956, PT960, ZET938, ZET95830″ (76.2 cm)Metal Bottom TrimAssembly27″ (68.6 cm)Metal Bottom TrimIf you have questions, call 1.800.GE.CARES or visit our website at:ge.com