17Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Supportge.comThe oven door must be closed and all controls must be set correctly for the cycle to work properly.How to Delay the Start of CleaningPress the SELF CLEAN STD/LOW padonce for a 4-hour clean time ortwice for a 3-hour clean time.A 3-hour self-clean time isrecommended for use whencleaning small, contained spills. Aself-clean time of 4 hours or longeris recommended for a dirtier oven.If a time other than 4 hours or3 hours is needed, use the HOURand MIN + or – pads and enterthe desired clean time.You can change the clean time to anytime between 3 hours and 5 hours,depending on how dirty your oven is.Press the DELAY START pad.Using the HOUR and MIN + or –pads, enter the time of day you wantthe clean cycle to start.Press the START pad.The door locks automatically. The displaywill show the start time. It will not bepossible to open the oven door untilthe temperature drops below the locktemperature and the LOCKED lightgoes off.When the LOCKED light goes off, you willbe able to open the door.NOTE: On models with touch pad controls forboth ovens, you can set a delay clean in bothovens at the same time. The second oven set willautomatically delay the start of cleaning until theend of the first oven’s clean cycle.To recall the start time of the second oven set,press the DELAY START pad on the controls forthe second oven.After a Clean CycleYou may notice some white ash in theoven. Wipe it up with a damp cloth afterthe oven cools.If white spots remain, remove them with asoap-filled scouring pad and rinse thoroughly witha vinegar and water mixture.These deposits are usually a saltresidue that cannot be removed bythe clean cycle.If the oven is not clean after one cleancycle, repeat the cycle. You cannot set the oven for cookinguntil the oven is cool enough for thedoor to unlock. If the shelves become hard toslide, wipe the shelf supports withcooking oil.