GE JTP20 Installation Instructions Manual

Also see for Monogram ZEK938: Installation instructions Installation instructions Technical service guide Installation instructions Installation instructions

Contents

GE JTP20 Installation Instructions Manual Manual pdf 1 page image

130” Built-In Wall OvenInstallationInstructions JTP20, JTP25, JTP28, JTP48, JTP50, JT912,JT915, JT952, JT955, ZET938, ZET958If you have questions, call 1.800.GE.CARES or visit our website at:ge.comBefore You BeginRead these instructions carefully and completely.• IMPORTANT —Save theseinstructions for local inspector’s use.• IMPORTANT —Observe allgoverning codes and ordinances.• Note to Installer—Be sure to leave theseinstructions with the consumer.• Note to Consumer—Keep theseinstructions for future reference.• Proper installation is the responsibilityof the installer and product failure dueto improper installation is NOT coveredunder warranty.• NOTE—This appliance must be properlygrounded.• ATTENTION INSTALLERAll electric wall ovens must be hard wired(direct wired) into an approved junctionbox. A plug and receptacle is NOT permittedon these products.Tools Needed1/8” Drill Bit andElectric or Hand DrillPhillipsScrewdriverMaterials NeededStrain Relief Clampfor 1/2” conduitJunctionBoxWire Nuts36” of String31-10659 1-07 JRParts IncludedScrews ForInstallationMetalBottom TrimPlasticBottom TrimOptionalMetal BottomTrim Assembly(on some models)