4-2 F60 Feeder Protection System GE Multilin4.1 ENERVISTA UR SETUP SOFTWARE INTERFACE 4 HUMAN INTERFACES4d) VIEWING ACTUAL VALUESYou can view real-time relay data such as input/output status and measured parameters.e) VIEWING TRIGGERED EVENTSWhile the interface is in either on-line or off-line mode, you can view and analyze data generated by triggered specifiedparameters, via one of the following:• Event Recorder facility: The event recorder captures contextual data associated with the last 1024 events, listed inchronological order from most recent to oldest.• Oscillography facility: The oscillography waveform traces and digital states are used to provide a visual display ofpower system and relay operation data captured during specific triggered events.f) FILE SUPPORT• Execution: Any EnerVista UR Setup file which is double clicked or opened will launch the application, or provide focusto the already opened application. If the file was a settings file (has a URS extension) which had been removed fromthe Settings List tree menu, it will be added back to the Settings List tree menu.• Drag and Drop: The Site List and Settings List control bar windows are each mutually a drag source and a drop targetfor device-order-code-compatible files or individual menu items. Also, the Settings List control bar window and anyWindows Explorer directory folder are each mutually a file drag source and drop target.New files which are dropped into the Settings List window are added to the tree which is automatically sorted alphabet-ically with respect to settings file names. Files or individual menu items which are dropped in the selected device menuin the Site List window will automatically be sent to the on-line communicating device.g) FIRMWARE UPGRADESThe firmware of a F60 device can be upgraded, locally or remotely, via the EnerVista UR Setup software. The correspond-ing instructions are provided by the EnerVista UR Setup Help file under the topic “Upgrading Firmware”.Modbus addresses assigned to firmware modules, features, settings, and corresponding data items (i.e. defaultvalues, minimum/maximum values, data type, and item size) may change slightly from version to version of firm-ware. The addresses are rearranged when new features are added or existing features are enhanced or modified.The EEPROM DATA ERROR message displayed after upgrading/downgrading the firmware is a resettable, self-testmessage intended to inform users that the Modbus addresses have changed with the upgraded firmware. Thismessage does not signal any problems when appearing after firmware upgrades.NOTE
