CHAPTER 5: SETTINGS FLEXLOGICF60 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL 5-1875to the first "END" operator.The "On" and "Off" operands can be placed in an equation to establish a known set of conditions for test purposes, andthe "INSERT" and "DELETE" commands can be used to modify equations.5.6.5 FlexLogic equation editorSETTINGS FLEXLOGIC FLEXLOGIC EQUATION EDITORThere are 1,024 FlexLogic entries available, numbered from 1 to 1024, with default END entry settings. If a "Disabled"element is selected as a FlexLogic entry, the associated state flag is never set to ‘1’. Press the +/– key when editingFlexLogic equations to quickly scan through the major parameter types.5.6.6 FlexLogic timersSETTINGS FLEXLOGIC FLEXLOGIC TIMERS FLEXLOGIC TIMER 1(32)There are 32 identical FlexLogic timers available. These timers are used as operators for FlexLogic equations.TIMER 1 TYPE — Selects the time measurement unit.TIMER 1 PICKUP DELAY — Sets the time delay to pickup. If a pickup delay is not required, set this function to "0."TIMER 1 DROPOUT DELAY — Sets the time delay to dropout. If a dropout delay is not required, set this function to "0."5.6.7 FlexElementsSETTINGS FLEXLOGIC FLEXELEMENTS FLEXELEMENT 1(8) FLEXLOGIC EQUATION EDITOR FLEXLOGIC ENTRY 1:ENDRange: FlexLogic operands FLEXLOGIC ENTRY 1024:ENDRange: FlexLogic operands FLEXLOGIC TIMER 1 TIMER 1TYPE: millisecondRange: millisecond, second, minute TIMER 1 PICKUPDELAY: 0Range: 0 to 60000 in steps of 1 TIMER 1 DROPOUTDELAY: 0Range: 0 to 60000 in steps of 1 FLEXELEMENT 1 FLEXELEMENT 1FUNCTION: DisabledRange: Disabled, Enabled FLEXELEMENT 1 NAME:FxE 1Range: up to six alphanumeric characters FLEXELEMENT 1 +IN:OffRange: Off, any analog actual value parameter FLEXELEMENT 1 -IN:OffRange: Off, any analog actual value parameter FLEXELEMENT 1 INPUTMODE: SIGNEDRange: SIGNED, ABSOLUTE FLEXELEMENT 1 COMPMODE: LEVELRange: LEVEL, DELTA FLEXELEMENT 1DIRECTION: OVERRange: OVER, UNDER
