8-2Accessing WebAdminIn order to access the printer using WebAdmin, the printer must be attached toan Ethernet network and running TCP/IP. If the printer has not been assignedan IP address, consult Chapter 7 of this manual, “Networking the Elite 21Series Printer.”WebAdmin can be accessed one of two ways. If you know the IP address ofthe printer, you can type the address directly into the Address field of your webbrowser. For example, if the printer’s IP address is 1.2.3.4, you would type inthe following in the Address field:http://1.2.3.4If the IP address of the printer is not known, or if there are multiple GCCprinters on the network, you can also use the MAP (Management AccessProgram) software included with the printer. This software is a Windows-basedutility which locates GCC printers on the network.To use the MAP utility, run the MAP installer on the Elite 21 CD-ROM byinserting the CD-ROM in the PC, opening the Network folder on the CD,opening the MAP 3.72 folder inside this folder and double-clicking theSETUP.EXE file icon. This will install the MAP program and include it on thePrograms menu of Windows.Before running MAP, you should run the MAP Setup utility to set whether MAPshould look for printers using TCP/IP, IPX/SPX or both. The default setting isfor the utility to check both, however this can cause error messages to appearif one or the other of the protocols is not enabled on your PC.To run MAP, go to the Start button of Windows, then to Programs and down toMAP. Select the MAP Setup item in the MAP folder. This will open a window asshown on the next page:
