Fujitsu Stylistic LT C-500 Installation Instructions Manual

Also see for Stylistic LT C-500: User guide User guide Installation guide Installation instructions User guide

Stylistic LT C-500 is a trademark of Fujitsu PC Corporation © 2000 Fujitsu PC Corporation7/00 58-0741-00AFMWSP11Screen ProtectorInstallation InstructionsStylistic LT C-500The FMWSP11 screen protector is designed for useon the Stylistic LT C-500 pen tablet display screen.Figure 1. Peeling Protective FilmInstallation Instructions 01. Peel the protective film from the adhesive side ofthe screen protector, as shown in Figure 1.2. Install the screen protector on the pen tabletdisplay screen. Apply the adhesive side to thescreen with the notch in the lower left corner, asshown in Figure 2.Notes• Before installing a new screen protector,remove any screen protector that is alreadyinstalled. A notch in the corner of the screenprotector allows you to slide a firm, pliableimplement (such as a credit card) under thescreen protector for removal. Do not use ametal implement; it could scratch the screen.• To ensure good adhesion, clean the screenwith a soft cotton cloth dampened withisopropyl alcohol before installing the screenprotector. When the alcohol dries, it mayleave streaks on the screen. If streakingoccurs, buff the screen gently with a clean,dry cloth to remove streaks.3. Apply pressure along the edges of the screenprotector with your finger. (Avoid lifting the screenprotector from the screen after it is installed. Theadhesive requires 48 hours to cure properly.)Figure 2. Installing the Screen Protector4. Remove the protective film from the top of the screenprotector, as shown in Figure 3.5. Wipe the exposed surface of the screen protector with aclean dry cloth to remove any adhesive left behind bythe protective film.Figure 3. Removing the Protective Film

/ 1

Related manuals for Fujitsu Stylistic LT C-500