Fujitsu M10 Product Notes

Also see for M10 Series: Installation guide Installation guide Installation planning manual Product notes

Contents

Therefore, the XSCF does not need to be reset.■ The ioxadm poweroff(8) command can be specified with the -f option only for apower supply unit.■ Configuring a memory mirror setting by using the setupfru(8) command shouldbe done when the physical partition (PPAR) to which the target system board(PSB) belongs is powered off.■ To display a man page, set TERM=vt100 for the terminal software.■ When configuring a physical partition (PPAR), do not set a BB-ID that does notexist in the system as the PPAR-ID.For example, if BB-IDs 00 and 01 exist in the system, you can set 00 or 01 as thePPAR-ID. If you set 02 as the PPAR-ID, the PPAR with PPAR-ID 02 becomesunable to start.■ Among the information displayed by executing the showhardconf(8) command,the PCI Express (PCIe) card information of the guest domain will be reflected afterOracle Solaris of the corresponding guest domain has started.■ As of XCP 2032, the default value for the power save operation set by thesetpparmode(8) command is changed from "enabled" to "disabled."■ When you execute the testsb(8) or diagxbu(8) command, a PPAR-ID of "PPAR#30"that does not exist may appear in an error log suspected area. This indicates thatan error was detected on the system board (PSB) while diagnosing. The outputPPAR-ID does not have any meaning.■ We recommend to connect the control domain console via the XSCF-LAN port.When a large amount of data is output by connecting to the control domainconsole via a serial port, the data may not be displayed properly.■ [SPARC M10-4S]The time taken for processing a command that displays the system configurationor status (such as showhardconf(8) command, showboards(8) command, andshowpparstatus(8) command) depends on the number of SPARC M10-4S chassisor crossbar boxes that configure the system.■ [SPARC M10-4S]For a system configured with multiple chassis, chassis BB#01 or XBBOX#81 maybecome the master XSCF first.■ [SPARC M10-4S]Depending on the system configuration, it may take time to reboot.■ If you add a SPARC M10-4S to the SPARC M10-4S on which XCP 2032 is installed,update to the latest firmware in advance.■ When you execute the setsnmpvacm(8) command specifying createview as theoperand, you cannot set an access restriction using the OID mask of MIB. Whenyou execute the setsnmpvacm(8) command specifying createview as the operand,do not use the OID mask of MIB.■ If a takeover IP address has been set, the UDP packet sender IP address and AgentAddress for the SNMP Trap of SNMPv1 are different. The IP address assigned toeach XSCF-LAN (physical IP address) is stored as the UDP packet sender IPaddress, while the takeover IP address (virtual IP address) is stored as the AgentAddress.Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2240 ･ March 201528