Fanimation The Odyn FPD8148 Owner's Manual

Contents

Fanimation The Odyn FPD8148 Owner's Manual Manual pdf 7 page image

7How to Assemble Your Ceiling Fan1. Remove the hanger ball portion from the downrod/hanger ball assembly by loosening the set screw in thehanger ball until the ball falls freely down the downrod.Remove the pin from the downrod, then remove thehanger ball. Retain the pin and hanger ball for reinstal-lation in Step 6. (Figure 1)DownrodSet Screws (2)DownrodBlack, White andsafety cable wiresSet ScrewPinHanger BallFigure 1Figure 2Figure 33. Loosen the two set screws in the downrod supportof the motor assembly. Route the black, white andsafety cable wires through the downrod. (Figure 3)4. Slide downrod into the downrod support on top ofthe motor. Install the clevis pin by aligning the holesin the downrod support with holes in the downrod.Secure clevis pin with hairpin clip. Tighten the two setscrews with nuts in the downrod support. (Figure 4)WARNINGIt is critical that the clevis pin in the downrod supportis properly installed and the set screws and nuts aresecurely tightened. Failure to do so could result inthe fan falling.2. Remove the hairpin clip and clevis pin from thebottom of the downrod. Retain the pin and clip forreinstallation in Step 4. (Figure 2)HairpinClipClevis PinDownrodSet Screws andLocking Nuts (2)Hairpin ClipClevis PinFigure 4Figure 55. Route wires through Motor Coupling Cover, CanopyScrew Cover and Ceiling Canopy. (Figure 5)Motor CouplingCoverCeiling CanopyCanopy ScrewCover