Fanimation The Odyn FPD8148 Owner's Manual

Contents

Fanimation The Odyn FPD8148 Owner's Manual Manual pdf 12 page image

12How to Assemble Your Light Kit Assembly or Cap1. Remove one of the three screws in the supportbracket at the bottom of the motor assembly.Slightly loosen the remaining two screws. Assemblethe light plate assembly to the support bracket usingthe two key slots in the socket plate. Replace the thirdscrew and securely tighten all three screws. (Figure 1)LED AssemblyGlassSteel Cap Assembly2 (Option A--for use with light kit)Connect the 2 single-pin connectors from the LEDassembly to the 2 single-pin connectors from motorassembly. (Figure 2A)2 (Option B--for use with steel cap)If you want to install the steel cap and not the light kit.Assemble the steel cap to the light plate assembly bytwisting in a clockwise direction. (Figure 2B)Light PlateAssemblyLight PlateAssemblyLight PlateAssemblySCREWS (3)Figure 1Figure 4Figure 2A Figure 2BTo reduce the risk of electric shock, disconnect theelectrical supply circult to the fan before installinglight kit.CAUTIONNOTE: If you have installed your fan with the steel cap,skip steps 3 and 4.LED AssemblyLight PlateAssemblyFigure 33. Remove three screws in the light plate assembly.Assemble the LED assembly to the light plate assemblyusing the two key slots. Replace the third screw andsecurely tighten all three screws. (Figure 3)4. Secure the glass to light plate assembly by twistingin a clockwise direction. Do not over-tighten. (Figure 4)The light source is designed for this specificapplication and can overheat if serviced by untrainedpersonnel. If any servicing is required, the productshould be returned to an authorized service facilityfor examination or repair.CAUTION