Before using the projector, make sure you read the safety instructions inthe User’s Guide on your projector CD.1 Locate the required cables:2 Connect the computer cable tothe blue Computer (Component Video)port on the projector.3 Connect the other end to your notebook’svideo-out or monitor port.4 Connect the power cord to theprojector, then plug the other endinto an electrical outlet.1 Turn on your notebook.2 Open the A/V Mute slide (lens cover).NOTE: The slide must beopened completely.3 Make sure the Power lightis orange and not flashing.4 Press the Power buttonto turn on the projector.The projector beeps once,and the Power light flashesgreen and then stays on.STARTHERETurn on your equipmentConnect the projectorto your notebookFollow these instructions to connect the projector to yournotebook. For other setup options, see your User’s Guide.PowerLite®1720/1730WQuick SetupVGA computer cable1 If you’ve turned on your notebook and switched it to external display,but you don’t see an image, press the Source Search button on theprojector or the Search button on the remote control to select theimage source.NOTE: If you still see a blank screen or have other display problems,see the troubleshooting tips on the back of this sheet.2 To raise the image, pressthe foot release buttonfor the front adjustablefoot and lift the front.Release the button tolock the foot in position.3 Turn the focus ring to sharpen the image.Turn the zoom ring to reduce orenlarge the image.4 If your image looks like or , you’ve placed the projector offto one side of the screen at an angle. Place it directly in front of thecenter of the screen, facing the screen squarely.5 If your image looks like or , press the or buttonon the projector to correct it.Adjust the imageTo shut down the projector, press the Power button twice andsimply unplug it. You don’t have to wait for the projector to cool off.Turn overPower lightPower buttonZoomFocusPower cord*411482100**411482100*