72Parameter DescriptionUnlock RespondingIntervalAfter unlock, the interval that the device responds to the nextunlock. The unit is “second”.Unlock Period After unlock, the period that it remains unlocked. The unit is“second”.Check Door SensorSignal Before LockTick “Check Door Sensor Signal Before Lock” to enable thefunction. If door sensor signal exists, it will not be locked. However,after opening time exceeds the door sensor check time, give doorsensor alarm and report the alarm info to management centreautomatically.Door Sensor CheckTimePassword Unlock Type Support the following two ways:Personal password: it can be set at VTH.Unified password: after setting, every userof the unit can unlock with this password.This parameteris displayedafter keyboardmodule isconnected andadded tofaçade layout.New Unlock PasswordNew Unlock PasswordConfirmNew MenacePasswordTick “Menace Password Enable” to enable thisfunction.In case of menace, input the menace passwordto unlock; the device uploads the alarm info tomanagement center automatically.New MenacePassword ConfirmAuto SnapshotTick “Enable”. 2 pictures will be snapshotautomatically when the door is opened, anduploaded to FTP.Upload Unlock Record Reserved function.Issue Card1. Click “Issue Card”.2. Swipe the unauthorized card at VTO.Pop up “Card Info” interface.3. Enter “Room No.” and “Card No.”, and click“OK”.Cards can be swiped continuously, within aperiod of 30s.4. Click “OK” to finish issuing card. Click “OK” within the countdown, so thecards will be valid. Otherwise, all card infowill be invalid. Click “Cancel” when issuing cards, in orderto stop issuing.This parameteris displayedafter cardswiping moduleis connectedand added tofaçade layout.Table 7-8Click “OK” to save the settings.Step 3