Menu
Dahua Modular VTO User Manual
Also see for VTO2000A-B: Quick install guide
                                                                                                        | |
Contents
| 
33Figure 5-23Add VTO or fence station.Step 4 Add main VTO.In Figure 5-23, enter main VTO name, VTO IP, “User Name” and “Password”.1.Switch the “Enable Status” to be .2. “User Name” and “Password” shall be consistent with WEB login user nameand password of VTO. Otherwise, it will fail to connect. “Enable Status” of main VTO is “ON” by default. After setting VTO info, pleaseturn it off and then reboot, in order to put it into effect. Add fence station.Press to switch to sub VTO setting interface.1.Select device type to be “Fence Station”, enter sub VTO name (fence station2.name), VTO middle no. (fence station middle no.), “User Name” and “Password”.Switch the “Enable Status” to be .3.5.2 Debugging Verification5.2.1 Verification with Version 3.1 VTH5.2.1.1 VTO Calls VTHPress call key at VTO or dial VTH room no. (9901) to call VTH. VTH pops up monitoring imageand operating keys, as shown in Figure 5-24. It represents successful debugging. |
Related manuals for Dahua VTO2000A-B
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved