29Power on the device.Step 1The system displays “Welcome” and enters “Device Initialization” interface, as shown inFigure 5-17.Figure 5-17Enter “Password”, “Confirm Pwd” and “Email”. Click [OK].Step 2The system displays main interface.5.1.3.2 Network SettingsSet VTH network info according to actual network access mode.IP addresses of VTH and VTO shall be in the same network segment. Otherwise, VTH will failto obtain VTO info after configuration.Press [Setting] for more than 6 seconds.Step 1The system pops up “Password” prompt box.Enter the password set during initialization, and click [OK].Step 2Click [Network].Step 3The system displays “Network” interface, as shown in Figure 5-18 or Figure 5-19.Only devices with wireless function own wireless network access function.
