D-Link Unified Access System Software User Manual12/10/09Page 382 Captive Portal Configuration Document 34CSFP6XXUWS-SWUM100-D7Viewing the Client CP Association StatusUse the CP - Client Status page to view clients that are authenticated to a specific CP configuration.Figure 270: CP - Client StatusThe drop-down menu lists each CP configured on the switch. To view information about the clients connected to the CP,select it from the list.The following table describes the fields on the Client CP Association Status page.SNMP TRAP CONFIGURATIONUse the SNMP Trap Configuration page to configure whether or not SNMP traps are sent from the Captive Portal and tospecify captive portal events that will generate a trap.Table 239: Interface - Client StatusFieldDescriptionMAC Address Identifies the MAC address of the wireless client. If the MAC address is marked withan asterisk (*), the authenticated client is authenticated by a peer switch. In orderwords, the cluster controller was not the authenticator.IP Address Identifies the IP address of the wireless client.CP Configuration Identifies the captive portal the client used to access the network.Protocol Shows the current connection protocol, which is either HTTP or HTTPS.Verification Shows the current account type, which is Guest, Local, or RADIUS.Table 240: CP - Client StatusFieldDescriptionMAC Address Identifies the MAC address of the wireless client. If the MAC address is marked with anasterisk (*), the authenticated client is authenticated by a peer switch. In order words, thecluster controller was not the authenticator.IP Address Identifies the IP address of the wireless client.Interface Identifies the interface the client used to access the network.Protocol Shows the current connection protocol, which is either HTTP or HTTPS.Verification Shows the current account type, which is Guest, Local, or RADIUS.
