Craftsman IB-28140 Owner's Manual

PREPARING THE ROUTER TABLE FOR USEI A WARNINGI Lift router table only byIAU= I the table edges. Liftingtable by any other surface could causepersonal injury.HELPFUL TOOLS TO HAVE ON HAND, #1 and #2 Phillips screwdrivers(not included),3/8-in. wrench or nut driver (not included)UNFOLDING AND LOCKING LEGS(Figs. 1 and 2)1. Gently lift and place the router tableassembly upside down on the tabletop (1).2. Gently pull both leg assemblies (8 and 10)inward towards center of the table until theleg assemblies are in the unlocked positionas shown in Fig. 1.I _WARNINGI Always rotate legassembly from end of legand keep fingers clear of joint. This avoidsa pinch point.I _,WARNINGI Never rotate legassemblies until thelocking tabs have been completelydisengaged. This will prevent possibledamage to the locking tabs or table housings.3. After the leg assemblies (8 and 10) areunlocked, rotate both leg assemblies tothe fully upright and extended position.(See Fig. 2.)4. Gently press down on both leg assemblies(8 and 10) to secure and lock the left andright leg assemblies in the upright positionas shown in Fig. 2.Fig. 1LOCKED(LEGS SLIDTOWARDSOUTSIDE)UNLOCKED(LEGS SLIDTOWARDSCENTER)Fig. 2UNLOCKED(LEGS SLIDUP AWAYFROM TABLE)LOCKED(LEGS SLiDDOWNTOWARDS TABLE)11