Craftsman 11593 Operator's Manual

Contents

A WARNING: Do not attempt to modify this productor create accessories not recommended for use withthis product. Any such alteration or modification ismisuse and could result in a hazardous conditionleading to possible serious personal injury.,& WARNING: To prevent accidental starting thatcould cause serious personal injury, always removethe battery pack from the product when assemblingparts.REMOVING THE WARNING LABELSee Figure 2.The spotlight has an attached paper warning label on thelens. Remove this warning label before use as shown infigure 2.PULLTABTOREMOVEFig. 2A WARNING: Do not allow familiarity with products tomake you careless. Remember that a carelessfraction of a second is sufficient to inflict seriousinjury.A WARNING: Always wear safety goggles or safetyglasses with side shields when operating products.Failure to do so could result in objects being throwninto your eyes, resulting in possible serious injury.A WARNING: Do not use any attachments oraccessories not recommended by the manufacturerof this product. The use of attachments oraccessories not recommended can result in seriouspersonal injury.APPLICATIONSYou may use this product for the purposes listed below:• To illuminate any areas requiring additional light• To illuminate distant objects_ WARNING: The lens gets very hot during use. Toreduce the risk of burns, do not touch hot lens. Toreduce the risk of fire, keep away from combustiblematerials while in operation.CAUTION: Operate in a well ventilated area. Donot block vents. Keep them clear to allow properventilation.This product will accept DieHardo 19.2 V lithium-ionbattery packs and Craftsman 19.2 V nickel-cadmiumbattery packs.For complete charging and battery instructions, refer tothe Operator's Manual for the battery packs and chargerslisted in the General Safety Rules.BATTERY PROTECTION FEATURESDieHardo 19.2 V lithium-ion battery packs are designedwith features that protect the lithium-ion cells andmaximize battery life.If the tool stops during use, release the trigger to resetand resume operation. If the tool still does not work, thebattery needs to be recharged.