Craftsman 113.228360 Owner's Manual

location and function of controls1. ON-OFF SWITCH .... Turns lathe on and off andlocks lathe in off position.2. TOOL REST SLIDE .... Allows the tool rest tobe moved along the bed.3. TOOL REST SLIDE LOCK .... Locks the toolrest slide to the bed.4, TOOL REST LOCK .... Locks the tool rest to thetool rest base.5. TAILSTOCK LOCK .... Locks the taitstock to thebed.6. TAILSTOCK .... Slides along the bed and supportsthe workpiece for spindle turning.7. SPINDLE LOCK .... Locks the spindle in thetailstock.8. HANDWHEEL .... Moves the tailstock spindleinto correct position for support of workpiece whenspindle turning.9. TAILSTOCK SPINDLE .... May be moved backand forth by rotating the handwheel, Supports thecup center.10, CUP CENTER (DEAD CENTER) .... Installedinto the tailstockspindle,., supports the workpieceon center at the tailstock.., referred to as deadcenter because it does not rotate.11. TOOL REST .... Supports the turning tool.12. TOOL REST HOLDER .... Allows positioning ofthe tool rest correct distance away from workpiece.13. TOOL REST HOLDER LOCK .... Locks the tool _orest holder to the tool rest slide. ,z_ -,_14. HEADSTOCK SPINDLE Supports the spur _ ocenter. '-._o"_15. SPUR CENTER .... Installed in the headstock "_ ,-spindle.., supports the workpiece on center at _ -_lhe headstock . . , transfers power from the -Jheadstock to workpiece causing the workpiece to ,,-'rotate.., referred to as a live center because itrotates.16, MOTOR COVER .... Protects operator from con-tact with hot motor and drive belts.17, SPEED CHART .... Indicates general recom-mended speeds for various sizes of workpieces.SF_N_E T_--875F*_£ EPt _T £ TUR P_JJO _1 _5.l 1_ __ SPINDLE --+2++oSPEED --_4soI MOTOR18. BELT TENSION ADJUSTMENT LEVER ....Allows proper tensioning of the drive belt.WARNING: To avoid Injury from thrown pieces,always use lowest speed when starting a newworkpiece, using faceplate, or turning betweencenters to avoid possible Injury.9