Craftsman 113.228360 Owner's Manual

HOLDING THE WOODWORKING CHISELIn handling alt turning tools, the handle hand takes anatural position, being nearer or farther from the endof the handle depending on the amount of leveragerequired. The position of the tool rest hand should beas illuslrated with turning tool held firmly against thetool rest and fingers and thumb wrapped around theturning tool on the opposite side of the tool rest, awayfrom the rotating workpiece.TOOLRESTWORK PIECETOOL RESTWARNING: To avoid Injury from a thrown turningtool, keep firm hand grip on the tool by wrappingfingers and thumb around tool. Use both handsspaced apart for proper leverage and control.Keep your weight balanced on your feet. Do not restyour weight on the turning tool or tool rest. Avoid awk-ward hand positions where a sudden slip could causea hand Io move into the workpiece.WOODCUTTINGCHISELHANDLEHANDmaintenanceWARNING: For your own safety, turn switch "off"and remove plug from power source outlet beforemaintaining or lubr]catlng your lathe.Apply a coat of automobile-type wax to the lathe bedto help the tool rest and tailstock move freely.Have power cord replaced if it becomes wornor frayed.I_..--WlR E NUTHITE-'I II I ._._,_.h_[ BLACK S_ITC-L_HtnlubricationPeriodically lubricate the ram in the tailstock with No.20 or No. 30 engine oil.MOTOR MAINTENANCE ANDLUBRICATION1. The bearings, in both end shields of the motor,have been lubricated at the factory with correctlubricant. No other part of the motor requireslubrication.2, If disassembly of the motor is necessary, it shouldbe returned to your nearest Sears retail ormail-order store in order to prevent voiding theguarantee,NOTE: The speed of this motor cannot be regulatedor changed,3_ Every effort should be made to prevent foreign ma-terial from entering the motor. When operatedunder conditions likely to permit accumulations ofdust, dirt, or waste within the motor, a visual inspec-tion should be made at frequent intervals. Accumu-lations of dry dust can usually be blown outsuccessfully.NOTE: Motors used on wood-working tools areparticularly susceptible to the accumulation of saw-dust and wood chips and should be blown out or"vacuumed" frequently to prevent interference withnormal motor ventilation.3O