Craftsman 113.228360 Owner's Manual

12. Adjust the tool rest approximately 1/8" away fromthe corners of the wood and 1/8" above the centerline. Note the angled position of the tool rest base.WARNING: For your own safety, after adjusting• tool rest be sure and lock the tool rest holder,e tool rest slide and the tool rest.Look at the speed chart. Notice that a 2" squareturning up to 18" long should run at 875 R.P.M. for"roughing." Move the Poly-V-Belt on the pulleys tothe slowest speed as outlined under "ChangingSpeeds" section.When finish-turning any size wood, notice that therecommended speed of the lathe is increased con-siderably above the rough-turning speed.However, if excessive vibration occurs at any speedalways shut the lathe off immediately and reducethe speed until the vibration is not excessive.During any spindle turning operation check all locksfrequently for tightness. Also frequently check thefit of the cup center against the turning. Do notallow the wearing away of wood to cause a loose fit.WARNING: To avoid injury from thrown pieces,turn workplece by hand to make sure it doesn'thit any parts of the lathe. Always make sure theworkpiece is properly mounted and the lathe Isset at the proper speed (RPM) before re-insertingthe switch key. Never spindle turn workpieceslonger than these specified in the chart for thesizes shown. Never spindle turn workpiecesgreater than 4" square.\TOOL RESTWOODLINE==-'2d._ =._FACEPLATE TURNINGe II=i[_];,I_I::(,-_,.tli={olll_l/l_[l'll1z, ] =_ _4"MAX 875 1350 /I0 1 ,"MAX 1350 22505" 1 4"MAX 1350 22500" 1 4"MAX ..... 2'250 3450SPINDLE TU RNING1" l t2" 1350 34502" 1 18" 875 22503" 27" 875 22504" J 36" 875 2250 iFACEPLATE TURNINGWARNING: When doing faceplate turnings, alwaysfollow instructions supplied with the faceplate formounting the workpiece to the faceplate. (for one(1) possible exception--see "special note" to theright) workpieces not properly and securelyattached to the faceplate may come loose duringoperation, fly off, and hit the operator (fsceplatesare sold separately at SearHee the list of recom-mended accessories for the correct part numbers.)SPECIAL NOTE: The instructions with your faceplatemay tell you to remove the 3/4-16 hex nut from thespindle before installing your faoeplate. Instead of re-moving the 3/4-16 hex nut, tighten the faceplate upagainst the nut on Modet 113.228360 Wood Lathe.3/4-16 NUTFor information on how to do faceplate turning, refer tothe "Power Tool Know How" books available at yourSears store, (See the list of recommended accessoriesfor the correct part number.)Faceplates are attached to this wood lathe byscrewingthem onto the threaded section of headstock spindle andup against the 3/4-16 hex nut as shown in the diagram,Do not remove the 3/4-16 hex nut from the spindle whenmounting faceplates to the spindle on this model woodlathe./SPINDLEFACEPLATE27