QUICK START GUIDE1Cisco Model SPA 504G Quick Start GuideWelcomeThank you for choosing the Cisco Small Business IP phone. This guide describes how to install your phone and how to perform somebasic tasks.1 Installing Your IP PhoneUse this procedure to install the phone and connect it to your network.Do not insert a telephone line cord into the port marked “AUX”.Step 1. Turn the phone body over to expose the ports on the back ofthe unit.Step 2. Insert one end of the phone cord into the slot marked with aphone symbol (the Handset Port). Insert the other end intothe jack at the bottom of the handset (not shown).Step 3. (Optional) Connect the desk stand by lining up the tabs onthe desk stand with the slots on the back of the phone. Slidethe bottom tabs into the slots and lightly press down on thetop of the desk stand. It should easily slide into the top slots.Do not force.Step 4. If you are using an external power source, plug one end of the power cord into the building’s power outlet and insert the other end ofthe power cord into the phone base.Step 5. Connect your phone to the network using an Ethernet Connection. Insert one end of the Ethernet cable into the network port on thephone body marked “SW.” Insert the other end of the Ethernet cable into the appropriate device, such as a network switch, on yournetwork.Step 6. (Optional) To provide network access to a PC, connect one end of an additional Ethernet cable (not provided) to the PC port on theback of the phone body. Connect the other end of the Ethernet cable to the network port on your PC.Step 7. (Optional) To install the phone on a vertical surface, use the Cisco MB100 Wall Mount bracket. See the Cisco Small Business IP PhoneSPA 50X User Guide (SIP) or the Cisco Unified Communications Manager Express for the Cisco Small Business IP Phone SPA 50Xdocuments on www.cisco.com for more information. The Where to Go From Here section contains links to the documentation areaon www.cisco.com.