Canon imageclass MF229DW Quick Start Manual

Also see for i-SENSYS MF217w: Getting started User manual Getting started Service manual

Contents

Canon imageclass MF229DW Quick Start Manual Manual pdf 11 page image

11EnNOTE• You cannot connect both the wired LAN and wirelessLAN at the same time. In addition, the machine is set tothe "Wired LAN" by default.• When you connect to a network environment that is notsecurity protected, your personal information could bedisclosed to third parties. Please use caution.• If you connect through a LAN in the office, contact yournetwork administrator.Checking the RouterSelect the connection method to the wireless LAN. Select fromthe following two methods depending on the router (accesspoint) that you are using.● There is a button.This machine supports WPS(Wi-Fi Protected Setup). Youcan easily setup if your router(access point) has a button,and if the mark is on therouter.If you are not sure whether or not your router supports WPS,please see the manual included in the product, or contact theproduct manufacturer.● There is no button.If there is no button on yourrouter (access point), youmay manually select SSID andcomplete the settings. In thiscase, you need to rememberSSID and network key of yourrouter (access point).See “1 Check SSID or NetworkKey for a Wireless LAN Router/Access Point.” (P.11) to learnhow to fi nd out your SSID and network key.To set up with WPS PIN code method, or setup manually:e-Manual “Connecting to a Wireless LAN”Setting Wireless LAN(MF229dw/MF227dw Only)Push Button Mode1 Tap in the Home Screen.2 Tap .3 Tap .4 Read the message that is displayed, and tap .5 Tap .Wireless LAN SettingsWPS Push Button ModeWPS PIN Code ModeSSID SettingsPower Save ModeWireless LAN Information6 Tap .7 Press and hold* the button until the lamp lights orblinks.You should press the WPS button within 2 minutes afteryou tap in step 6.* The time that you should hold the button may vary dependingon the router you are using.8 Wait approximately 2 minutes after the connection.IP address is set during this period of time.When an error message appears:Tap to close the screen, check whether or not thenetwork key is correct, and then retry the settings. If theaccess point cannot be detected even after retrying,see the following.e-Manual “When an Error Message Appears”When checking the network connection:You can check if the machine is properly connected to thenetwork using a computer that connected to a network.e-Manual “Viewing Network Settings”To set IP address manually:e-Manual “Connecting to a Wireless LAN”Setting the Access Point Manually1 Check SSID or Network Key for a Wireless LANRouter/Access Point.• Check the label on the Wireless LAN router.• You can check the SSID or the network key using “CanonMF / LBP Wireless Setup Assistant,” which is included inthe User Software and Manuals DVD-ROM supplied withthe machine.