Canon imageRUNNERC1028iF Starter Manual

Also see for imageRUNNER C1028i: Manual

Canon imageRUNNERC1028iF Starter Manual Manual pdf 5 page image

3English2 Set Up the MachineTurn on the MachineThe display returns to the Standby mode:The machine may enter the Standby mode (Auto Clear function) while you are setting it up. Make the setting again from the main menu. The default setting is 2 minutes.To change the settings, see “Introduction of the Machine” in the e-Manual.The display turned OFF:The machine may enter the Sleep mode while you are performing setup. Press (Power) to turn the display back ON and continue the setup. The default setting is15 minutes. To change the settings, see “Introduction of the Machine” in the e-Manual.●●1 Press the [I] side of the main power switch (A)to ON.Do not connect the machine and the computer with aUSB cable at this time. Connect the machine and thecomputer with a USB cable only during the softwareinstallation procedure. (A USB cable is not used whenthe machine is used via a network connection.)Apply the power switch label to the space above themain power switch.––2 If the screen to select the language appears asshown below, use [▼], [▲] or (ScrollWheel) to select a language, then press [OK].The machine restarts automatically.The language setting can be changed later.Press (Main Menu) → → → → →Select → Select the desired language → Turn OFFthe main power → Restart the machine.3 If the screen to select the country/regionappears as shown below, use [▼], [▲] or(Scroll Wheel) to select a country/region, thenpress [OK].The machine restarts automatically.