Roll x is selected. (x is 1 (Upper) or 2 (Lower))Cause Corrective ActionThe indicated roll is specified for a print job sent from acomputer, but that roll is not loaded.Load the indicated roll and try printing again.To print on a sheet instead, hold down the Stop button formore than a second to cancel printing, load a sheet, and thenprint.(See "Loading and Printing on Sheets.") →P.8Roll x is empty. (x is 1 (Upper) or 2 (Lower))"Lift the release lever and replace the roll."Cause Corrective ActionThe roll is empty. Follow these steps to replace the used roll with a new rollof the same type and size.1. Lift the Release Lever and remove the roll.(See "Removing the Roll from the Printer.")→P.644(See "Removing the Roll Holder from Rolls.")→P.6492. Load the new roll.(See "Attaching the Roll Holder to Rolls.") →P.629(See "Loading Rolls in the Printer.") →P.6343. If no barcode was printed on the roll, specify the typeof paper.(See "Selecting the Paper Type (Roll).") →P.6424. If no barcode was printed on the roll, specify the paperlength.(See "Specifying the Paper Length (Roll).")→P.6435. If "Not finished printing. Finish printing remainingjobs?" is shown on the Display Screen, press the OKbutton.Printing will resume, starting from the page on whichthe error occurred.There is remaining roll paper, but because it could not beadvanced, it could not be detected.Choose a higher level of Print Quality in the AdvancedSettings of the printer driver and try printing again.(See "Giving Priority to Particular Graphic Elementsand Colors for Printing.") →P.56Error Message > Messages regarding paper >iPF825 Roll x is selected. (x is 1 (Upper) or 2 (Lower))13893
