Canon imagePROGRAF iPF825 Basic Guide No.2 Basic Manual

Also see for imagePROGRAF iPF815: Technical documents Brochure Basic guide Basic guide Setup guide

Contents

Canon imagePROGRAF iPF825 Basic Guide No.2 Basic Manual Manual pdf 41 page image

41Error MessagesCannot adjust printhead. The Printhead nozzles areclogged.Execute Auto Head Adj. again, as follows.Press the Online button to clear the error.1.Print a test pattern to check the nozzles.2.Clean the Printhead if the nozzles are clogged.3.Execute Auto Head Adj. again.4.The Printhead cannot be aligned;highly transparent film is loaded.Press the Online button to clear the error.Maximum jobs stored. 100 jobs are stored in the personalbox.Delete unneeded jobs stored in personal boxes.(→"Checking for Nozzle Clogging," User Manual)(→ , If Vertical Lines are Warped or Colors areMisaligned)(→ , If Printing is Faint)(→ , If Vertical Lines are Warped or Colors areMisaligned)The Printhead is installed crooked. Straighten the Printhead as follows, and then executeAuto Head Adj. again.Use Head Inc. Adj. to adjust the angle of inclinationof the Printhead.2.Execute Auto Head Adj. again.3.(→"Adjusting Line Misalignment (Head Inc. Adj.),"User Manual)(→ , If Vertical Lines are Warped or Colors areMisaligned)Cannot print as selected.Another roll is in use.A printed document remains inthe Output Tray without being cutand a print job was received thatspecifies the other roll.Follow these steps to load the other roll after cuttingthe printed document.Hold down the Stop button for a second or more tocancel printing.Cut the printed document.Load the other roll and resend the print job.Error Message Cause Corrective ActionMail box full. Now printingwithout saving data.No more space is available on theprinter's hard disk, so jobs are nowprinted without saving them. (Printjobs can no longer be saved on thehard disk.)After printing, this message is cleared.We recommend using a type of paper that you oftenuse, other than film, for Printhead adjustment.Press the Online button to clear the error.1.2.3.1.(→"Specifying the Cutting Method for Rolls," UserManual)(→"Loading and Printing on Rolls," User Manual)(→"Deleting Saved Jobs," User Manual)