Feed originals to the ADF (optional)IntroductionYou can use the ADF to feed a stack of originals at once, face up. Feeding originals in aportrait position is referred to as long edge feed (LEF/horizontal). Feeding originals in alandscape position is referred to as short edge feed (SEF/vertical).#NOTE■ If the top edge of the original is not aligned with the back edge of the slide guide,your original may not be scanned correctly, depending on the copy mode that youhave set.■ Originals of the A4, B5 and LTR sizes can be placed either vertically or horizon-tally. However, the scanning speed for horizontally placed originals is somewhatslower than vertically placed originals.■ Horizontally placed A4 and B5 originals are referred to as A4R and B5R.■ Horizontally placed LTR originals are referred to as LTRR■ A3, B4, 11" x 17" and LGL originals must be placed horizontally. A5 and STMTmust be placed vertically.You can place the following originals into the ADF:■ Weight- One-sided scanning: 50 to 216 g/m² / 13 to 57 lb Bond- Two-sided scanning: 50 to 216 g/m² / 13 to 57 lb Bond(A3, B4, A4R, B5R: 50 to 200 g/m² / 13 lb Bond to 54 lb Bond)(11" x 17", LGL, LTRR: 50 to 200 g/m2 / 13 to 53 lb Bond)■ ISO sizes: A3, B4, A4, A4R, B5, B5R, or A5(A5 originals cannot be placed horizontally. (A5R))■ US sizes: 11"x 17", LGL, LTR, LTRR, STMT(STMT originals cannot be placed horizontally. (STMTR))■ Tray Capacity: up to 100 sheets (80 g/m² / 22 lb Bond)Chapter 7 - Copy jobs 187Feed originals to the ADF (optional)
