Combine jobsIntroductionThe bundle function allows you to combine 2 or more jobs into 1 new job. For example.this can be convenient when the participants of a meeting need several documents in aspecific order. Often, the required documents are sent from several workplaces to theprinter in advance. Normally, this means that you must print the documents first andsort or staple them later. By using the bundle function you can determine the order ofthe documents before printing and print all documents in the correct order in only 1print job.Important information about the bundle function■ You can only bundle print jobs that are currently in the list of 'Waiting jobs'.■ You can change a number of settings for the bundled job via the 'Properties' window.■ By default, the number of sets for a bundled job is 1. So before printing, you mustfirst indicate the required number of sets (see...).■ When you stop a job after a set, the printing stops after 1 copy of the complete bundle.■ The jobs in a bundle are accounted separately under the account ID of the originaljobs.■ All the jobs in the bundle must have the same output location. Otherwise, the operatorpanel displays a warning message. To continue, you must first split the bundled job,then change the individual job settings and finally bundle the jobs again.Main actions on the bundle functionThe table below describes the main actions you can carry out with regard to the bundlefunction.Main bundle functions#DescriptionMain actionsWhen you touch 'Bundle' after selecting 2 or more jobs, anew job is created that contains the original jobs. The newjob is added to the bottom of the list of 'Waiting jobs'. Theoriginal jobs are removed from the list. The new job getsa new name that is based on the name of the first job inthe bundle.'Bundle'Chapter 6 - Print jobs 155Combine jobs
