Making Prints Using the Stack Bypass 2-13Basic Operations2Making Prints Using the Stack BypassIf you are making prints on transparencies or non-standard size paper stock, loadthe paper stock into the stack bypass. Standard SizeYou can select standard inch paper, or A or B series paper. Free SizeYou can load non-standard size paper (4" x 5 3/4" to 11 5/8" x 17" (100 mm x 148 mm to297 mm x 432 mm)). EnvelopeThe following envelopes can be loaded into the stack bypass: COM10, Monarch, andDL.IMPORTANTNote the following points when using the stack bypass:- Paper quantity: 1 to approximately 100 sheets (stack approximately 3/8" (10 mm) high)- Paper size: 4" x 5 3/4" to 11 5/8" x 17" (100 mm x 148 mm to 297 mm x 432 mm)- Paper weight: 16 to 32 lb bond (60 to 128g/m2)- Paper which has been rolled or curled must be straightened out prior to use, to allowthe paper to feed smoothly through the stack bypass (allowable curl amount: less than10 mm for normal paper, less than 5 mm for heavy paper.) There are some types ofpaper stock that may meet the above specifications, but cannot be fed into the stackbypass.Do not load different size/type paper at the same time.It is recommended not to use the back side of preprinted paper.If you are using label sheets, load them one by one on the stack bypass.LTR transparencies must be placed vertically into the stack bypass. Placing this paperhorizontally may cause blurred images.If you are printing on envelopes, empty the output tray when at most 10 printedenvelopes accumulate in the tray.For details about paper sizes when using the stack bypass, see "Standard Paper for theStack Bypass," on p. 3-16.NOTEFor high quality printouts, use paper recommended by Canon.
