Canon iPF830 Series Basic Manual

Also see for iPF830 Series: Quick guide

Contents

Canon iPF830 Series Basic Manual Manual pdf 124 page image

PaprWidth MismatchPaprWidth MismatchCause Corrective ActionWhen Detect Mismatch in the Control Panelmenu is set to Pause or Hold Job, the width of theloaded roll does not match the width specified inFit Roll Paper Width in the printer driver.Press ▲ or ▼ to select Print, and then press the OK button to resume print-ing.However, note that this error may cause paper jams and affect the printingquality.Press ▲ or ▼ to select Stop Printing, and then press the OK button.Follow these steps to replace the roll to match the width specified in the printerdriver.1. Press ▲ or ▼ to select Change Paper, and then press the OK button.(See "Removing the Roll from the Printer.") ➔ P.18(See "Removing the Roll Holder from Rolls.") ➔ User's Guide2. Replace with paper of the width configured in the printer driver.(See "Attaching the Roll Holder to Rolls.") ➔ P.12(See "Loading Rolls in the Printer.") ➔ P.15The printer now starts printing the print job.Make sure the roll width selected in the dialog box displayed when you selectFit Roll Paper Width in the printer driver matches the width of the roll loadedin the printer, and then try printing again.Paper size not detected.Paper size not detected.Cause Corrective ActionPaper has been loaded askew, or warped paper has been loaded. Lift up the Release Lever and reload thepaper.(See "Loading Rolls in the Print-er.") ➔ P.15(See "Loading Sheets in the Print-er.") ➔ P.21If "Not finished printing. Finish printingremaining jobs?" is displayed on the Dis-play Screen, press the OK button.Printing will resume, starting from thepage on which the error occurred.If this error recurs after you reload the roll,remove the Roll Holder from the printer,push the roll firmly in until it touches theRoll Holder flange, and reload the RollHolder in the printer.(See "Attaching the Roll Holder toRolls.") ➔ P.12Because the Platen is soiled with ink or other substances, the size of the clearfilm cannot be detected.Open the Top Cover and clean the entirePlaten.(See "Cleaning Inside the Top Cov-er.") ➔ P.47Insufficient paper for jobInsufficient paper for jobCause Corrective ActionThe printer has received a print job longer than the amount of roll paper left when Manag-eRemainRoll in the Control Panel menu is On.Press ▲ or ▼ to select Print, andthen press the OK button to resumeprinting.However, the roll paper may run outduring the print job and you may notbe able to print all of the document.PaprWidth Mismatch iPF830 SeriesBasic GuideError Message Messages regarding paper124