88EEditing5. Press AUDIO DUB.• AUDIO DUB. and appear on the display.6. Press the PAUSE button (and start play on the other audio deviceif AUDIO IN).• Audio dubbing starts.• If MIC. IN, direct your voice into the microphone.• changes to .7. When you get to the point where you want to stop dubbing, pressthe STOP button (and then stop play on the other audio device ifAUDIO IN).• Audio dubbing stops and AUDIO DUB. disappears from the display.• The camcorder returns to stop mode.• You can also set zero set memory ( 75) at the place you want to stopaudio dubbing, then every time you return to that position, audio dubbingwill cancel.• If instead of pressing STOP you press PAUSE, the camcorder will return tothe playback pause mode.Notes:• You cannot use the DV terminal while adding sound.• You might want to adjust the audio mix ( 89) when playing back a tape withadded sound.• There may be a loss of sound quality if you add sound to a tape recorded on acamcorder other than the ZR40.• After adding sound 3 or more times to the same place on a tape, there may besome loss in sound quality.
