[RTP] Setting RTP Server, Audio Multicast and RTP Streaming615 Setting Pagedistribution is confined to the local segment only andcannot be distributed by the router.(6) [Audio Transmission]Set RTP streaming audio transmission to [Disable] or[Enable].Note• RTP stream URLrtsp://IP_address:port_number/rtpstream/config1(~5)=r|u|m[=r|u|m] is optional and can be omitted. If specified, specifyonly one option.r: Requests RTP over TCPu: Requests RTP over UDPm: Requests multicastExample: RTP streaming 1 request using RTP over TCPrtsp://192.168.100.1:554/rtpstream/config1=rNote that the actual operation is dependent on the RTP clientapplication, so the URL does not necessarily specify themethod used for transmission.• For H.264, the bit rate control and video quality are determinedby the settings in [Video] (p. 58).• Regardless of the [Server] > [Audio Server] > [AudioTransmission from the Camera] setting, RTP streaming audiowill be used.However, to use audio settings, select [Enable] for [AudioTransmission from the Camera] and make the settings.• The [Access Control] > [User Authority] > [Video Distribution]and [Audio Distribution] settings are not used for RTP.• RTP streaming video may not be viewable on systems using aproxy server or firewall. If the video cannot be viewed, contactthe system administrator.• If host access restrictions are applied to a client while it isstreaming using RTP over UDP, it may take from a few toseveral seconds until streaming ceases.
