Canon PIXMA MX420 Network Setup Troubleshooting

Also see for PIXMA MX420 Series: Specifications Manual Installation guide Getting started Network installation guide

Contents

Canon PIXMA MX420 Network Setup Troubleshooting Manual pdf 6 page image

ENGLISHCheckThe message appears when no access point is found bythe entered access point name/network name (SSID).Press the OK button to make sure that the entered access point name/network name(SSID) is correct, then press the OK button again.Check 1Is the entered access point name/network name (SSID)correct?Make sure that you follow Check 1, 2, 3 and 4 of "Connection Checklist" on page 15.Turn off the access point, then turn it back on.Check 3Check 2After that, press the OK button, then proceed with the setup from in "Entering the AccessPoint's Wireless LAN Settings Directly on the Machine" on page 11.•After that, press the OK button, then proceed with the setup from in "Entering the AccessPoint's Wireless LAN Settings Directly on the Machine" on page 11.•The directly entered access point was not detected. is DisplayedIs the MAC address filtering enabled on the access point?Set the access point to accept the MAC address of themachine.Check 4For details on how to change the settings of the access point,refer to the manual supplied with the access point or contact itsmanufacturer.•To check the MAC address of the machine, press the Setup button, then using the { } [ ]and OK buttons, select Device settings > LAN settings > Confirm LAN settings > WLANsetting list to check MAC address.•For details on how to check the settings of the access point, refer to the manual supplied with theaccess point or contact its manufacturer.•After that, press the OK button, then proceed with the setup fromin "Entering the Access Point's Wireless LAN Settings Directlyon the Machine" on page 11.•Check 5Is "WPA/WPA2 Enterprise" set as a security protocol (encryption standard) on theaccess point?"WPA/WPA2 Enterprise" is not supported on the machine.Change the security protocol (encryption standard) for the access point, then configuresettings again.For details on how to change the security protocol (encryption standard) for the access point,refer to the manual supplied with the access point or contact its manufacturer.•After that, press the OK button, then proceed with the setup from in "Entering the AccessPoint's Wireless LAN Settings Directly on the Machine" on page 11.•