Canon PIXMA MX420 Network Setup Troubleshooting

Also see for PIXMA MX420 Series: Specifications Manual Installation guide Getting started Network installation guide

Contents

Canon PIXMA MX420 Network Setup Troubleshooting Manual pdf 4 page image

ENGLISHCheckAccess point was not detected. is DisplayedThe message appears when no access point is found.Refer to "The Target Access Point is Not Displayed(Detected)" on page 2.CheckFailed to connect to the access point. is DisplayedCheck 1Is WEP key number 2, 3 or 4 of the access point in use?For details on how to check the WEP key number of the accesspoint, refer to the manual supplied with the access point orcontact its manufacturer.•Set to use WEP key number 1 of the access point, or select a WEP key number byentering wireless connection settings of the machine directly.For details on how to change the WEP key number of the access point, refer to the manualsupplied with the access point or contact its manufacturer.•For details on how to select a WEP key number by entering wireless connection settings of themachine directly, refer to "Entering the Access Point's Wireless LAN Settings Directly on theMachine" on page 11.•Are you using an access point that automatically creates WEP keys?Check the WEP key (hexadecimal) created automatically on the access point, thenenter it on the machine.For details on how to check the WEP key of the access point, refer to the manual supplied withthe access point or contact its manufacturer.•Check 3For details on the access point, refer to the manual supplied with the access point or contact itsmanufacturer.•Check 2Make sure that the DHCP function of the access point is active.For details on how to check the settings of the access point, refer to the manual supplied with theaccess point or contact its manufacturer.•Enable the DHCP function of the access point, then configure settings again.For details on how to change the settings of the access point, refer to the manual supplied withthe access point or contact its manufacturer.•Is the MAC address filtering enabled on the access point?Set the access point to accept the MAC address of themachine.Check 4For details on how to change the settings of the access point,refer to the manual supplied with the access point or contact itsmanufacturer.•To check the MAC address of the machine, press the Setupbutton, then using the { } [ ] and OK buttons, selectDevice settings > LAN settings > Confirm LAN settings >WLAN setting list to check MAC address.•For details on how to check the settings of the access point, refer to the manual supplied with theaccess point or contact its manufacturer.•