Canon PIXMA MX420 Network Setup Troubleshooting

Also see for PIXMA MX420 Series: Specifications Manual Installation guide Getting started Network installation guide

Contents

Canon PIXMA MX420 Network Setup Troubleshooting Manual pdf 5 page image

CheckMultiple access points with the same name exist. is DisplayedSelect Use multiple AccessPoints.For details on how to check the MAC address of the accesspoint, refer to the manual supplied with the access point orcontact its manufacturer.•Select Use one AccessPoint only, then select the MACaddress of the target access point.When using multiple access pointsGlossaryA unique number assigned to each network device.MAC address•For subsequent operations, go to or / / in "Entering the Access Point'sWireless LAN Settings Directly on the Machine" on page 11.•For subsequent operations, go to or / /in "Entering the Access Point's Wireless LAN Settings Directlyon the Machine" on page 11.•When you have only one access pointThe message appears when multiple access points withthe same name are found.GlossaryDHCP function•A function to automatically assign required information (IP address, etc.) to computers, printers or otherdevices connected to the network.Check 5Is TKIP set as an encryption standard when the access point is configured tocommunicate using IEEE802.11n standard only?If the encryption standard of the access point is set to TKIP, IEEE802.11n cannot beused as a communication standard.Set the encryption standard to other than TKIP or set the communication standard toother than IEEE802.11n, then configure wireless LAN settings again.For details on how to change the settings of the access point, refer to the manual supplied withthe access point or contact its manufacturer.•A function to block access from unauthorized wireless devices by saving the MAC addresses of specificwireless devices (computers, printers, etc.) to the access point beforehand.MAC address filtering•A unique number assigned to each network device.MAC address•