Canon PIXMA MX420 Network Setup Troubleshooting

Also see for PIXMA MX420 Series: Specifications Manual Installation guide Getting started Network installation guide

Contents

Canon PIXMA MX420 Network Setup Troubleshooting Manual pdf 13 page image

79865Enter the access point name/network name (SSID)using the Numeric buttons, then press the OK button.For details on how to check the access point name/network name (SSID), refer to themanual supplied with the access point or contact its manufacturer.•Enter the same access point name/network name (SSID)as that of the access point on the machine.•Enter upper and lower case letters of the alphabet correctly. Letters are case sensitive.•Go to either of the following steps according to the selectedsecurity protocol.•DisableWEPWPA/WPA2Go to . onpage 13.Go to on page13.Go to onpage 13.Select a security protocol for the access point, thenpress the OK button.When WEP 40 bit or WEP 128 bit is selected in AirPort Utility (AirPort Admin Utility), selectWEP.•When WEP (Transitional Security Network) is selected in AirPort Utility, select WPA2-PSK(AES).•For details on how to enter characters, refer to "CharacterEntry" on page 10.Make sure that the access point name/network name(SSID) is correct, then press the OK button.2-byte characters are not available for entering the access point name/network name(SSID).•When the access point is set to operate in IEEE802.11n and IEEE802.11g with TKIP set asan encryption standard, communication is established using IEEE802.11g.•When the access point is set to operate in IEEE802.11n, TKIP cannot be used. Change theencryption type to something other than TKIP or change the standard to something otherthan IEEE802.11n, then configure wireless LAN settings again.•Select Directly enter the access point name, thenpress the OK button.If you are living in an apartment, nearby access points inuse may be detected.•Select Advanced setup, then press the OK button.