Canon PIXMA MP450 User Manual

Also see for PIXMA MP450: Supplementary guide Manual Service manual Easy setup Start here

Contents

Canon PIXMA MP450 User Manual Manual pdf 66 page image

64 Chapter 7Printing Photographs Directly From A Digital Cameraz About “Layout” and “Trimming”For “Layout”, when the “Default setting” (selections based on the machine setting) isselected, the machine operates based on the bordered/borderless setting specified in theMemory card mode of the machine. Trimming is performed based on settings on thePictBridge-compliant device.z About “Image Optimize”When “Default setting” (selections based on the machine setting) is selected, the machineoperates based on the settings in tab 2 of the Settings screen specified in Memory cardmode of the machine. (See page 29)If you use a Canon PictBridge-compliant device, you can select “VIVID”, “NR”, “VIVID+NR”or “FACE”.(Note that these options cannot be selected on some models.)z About “Date/File No. print”By default, “Off” is selected for this machine.If you select an image which has had the shooting date embedded in it using a camera withthe print mode, select “Off” for this function. If you select “Date”, “File No.”, or “Both”, thedate and/or file number will be printed over the embedded date.Note z When printing onto Photo Stickers (PS-101) (16-up), use the followingsettings.1. Load Photo Stickers (PS-101) in the Auto Sheet Feeder.2. Select “10 x 15 cm / 4" x 6"” for the “Page size”, and “Photo” for the“Media type”.3. Select “N-up” for layout, then select “16”.z Some PictBridge compliant devices display the Layout option; 2-up, 4-up, 9-up, and 16-up. In this case always select “16-up”. If there are nooptions on the PictBridge compliant device that correspond to 2-up, 4-up, 9-up, or 16-up, printing on stickers is not possible.z When you are using Photo Stickers (PS-101), do not set “BorderlessPrinting” in “Layout” settings.Note z When “VIVID” is selected, the green and blue portions of photos areprinted more vividly.z When “NR” (Noise Reduction) is selected, noise in blue portions, suchas the sky, and dark portions is removed.z When “VIVID+NR” is selected, functions of both “VIVID” and “NR” areperformed.z When “FACE” is selected, a darkened face on the photo taken againstthe light is brightened.Note z Never disconnect the USB cable during printing.z When disconnecting the USB cable between the device and machine,follow the instructions given in the instruction manual of the device.z Controls of the device cannot be used for the following:– Print quality setting– Printer maintenancez For the device operation method and troubleshooting, refer to yourdigital device’s manual.