( ) Check the message Settings> or Perform a hard reset ( Performing aHard Reset(P. 448) )Discovery ResponseSelect whether to set the machine to respond to multicast discovery packets on the network. Use the Remote UIto specify the scope name that is used to include the machine into a specific scope. Configuring Settings forDevice Management Software(P. 231)OffOn( ) Check the message Settings> or Perform a hard reset (Performing a Hard Reset(P. 448) )IPSecSelect whether to perform encrypted communication by establishing a virtual private network (VPN) via IPSec.Use the Remote UI to register and specify the security policies. Configuring IPSec Settings(P. 291)OffOn( ) Check the message Settings> or Perform a hard reset ( Performing aHard Reset(P. 448) )Sleep Notif. Set.Specify settings for SLP communication to notify imageWARE of the power status of the machine. If you set to , you can expect the machine to avoid unnecessary communication during sleepmode and reduce the total power consumption. Configuring Settings for Device ManagementSoftware(P. 231)Sleep Mode Notif.Enable or disable SLP communication. If you select , the power status of the machine is notified toimageWARE.OffOnSetting Menu List379
