The power buttons and power modesThe power buttonsThe printer has the following switches and buttons to control the power supply.Button Name DescriptionPower switch The power switch is located on top of the fusing unit ofthe printer. The power switch connects and disconnectsthe printer to and from the main power.Sleep button The Sleep button is located at the right-hand side of theoperator panel. Using the Sleep button puts the printerinto sleep mode or wakes the printer up from the sleepmode. When you press the Sleep button, the operatorpanel will be turned off too. The PRISMAsync controllerremains on.The Sleep button allows you to switch between theReady mode and the Sleep mode. This is only possiblewhen the Power switch is in the 'O' position and thestart-up phase is completed.The power modesYou can find the energy saving settings in the Settings Editor under [Preferences] -> [Systemsettings] -> [Energy save modes].The power modesPower mode Operator panel DescriptionOff Off The printer and the controller are completely off. Thereis no power consumption. The printer cannot receive orprint any job.Ready On The printer is ready to print jobs.Low power mode Off The low power mode is an energy save mode.To use the low power mode, the [Low power mode tim-er enabled] setting in the Settings Editor must be set to[Yes]. When this setting is disabled, the printer skips thelow power mode and goes into the sleep mode or deepsleep mode after the time set for these modes.When the printer has been idle for the time defined inthe [Low power mode timer] setting, the printer goes in-to low power mode automatically.Possible values: 5 - 30 minutes.Factory default: 20 minutes.The printer wakes up when a job arrives in the list of[Scheduled jobs] or when you touch the operator panel(either the screen or any button). 4The power buttons and power modes42 Chapter 3 - Power information
