119Clip Operations2 Select the desired function and then press SET.• The function is enabled. For some functions, further action may be required. Follow the onscreen directions.• Press the CANCEL button instead to return to the clip index screen.IMPORTANT• Observe the following precautions while the CF2 or CF3 access indicator is illuminated in red. Failure to doso may result in permanent data loss.- Do not disconnect the power source or turn off the camcorder.- Do not open the cover of the either CF card slot.Displaying Clip InformationSelect [Display Clip Info] in the clip menu to display the selected clip’s information screen ([Clip Info] screen).Push the joystick left/right to switch to the previous/next clip. When you are finished, press the CANCEL buttonto return to the clip index screen.Displaying the Lens Information and User MemoFrom the [Clip Info] screen, push the joystick up or turn the SELECT dial up to display the [Lens & Q] screen.In this screen you can check details about the lens used to record the clip. If the clip has an embedded usermemo, you will see the user memo content in this screen as well. Push the joystick down or turn the SELECTdial down to return to the [Clip Info] screen.94 5 61238101314151617111271 Thumbnail of the selected clip2 Thumbnail of the previous clip3 Thumbnail of the next clip4 Shot mark (A 90, 124)5 Special recording mode (A 93)6 Currently selected CF card slot (A 43)7 Clip number / Total number of clips8 Recording date and time9 Clip name (A 51)10 Bit rate and resolution (A 55)11 Frame rate (A 55)For slow & fast motion recording mode, theshooting and playback frame rates will bedisplayed.12 $ mark / % mark (A 91, 120)13 Embedded custom picture file (A 91)14 Time code of the clip thumbnail15 Time code of the first frame in clip16 Time code of the last frame in clip17 Clip durationCOPY
