7Installation SpaceSelect an installation location where you can secure the following amounts offree space around the printer, and a surface that can support the weight of theprinter. The dimensions of the space required around the components and thepositions of the feet are as follows.For details on the installation space of the printer with the optional paper feederinstalled, see "Installing a Paper Feeder," on p. 51.Precautions for HandlingCAUTIONIf an error should occurred to the hard disk in the printer unit, thereceived, recorded, and saved data may be deleted. It isrecommended not to record or save important data on the hard disk.Canon assumes no responsibility whatsoever for any damages orlosses arising from data loss by the customers.Front SurfaceRequired Peripheral Space (LBP5975)3.94(100)(in. (mm))30.71 (780)60.81 (1544.5)29.13 (740)29.33 (745)5.32(135)3.94(100) 3.94(100) (in. (mm))Top coverFront coverPapercassetteFront SurfaceRequired Peripheral Space (LBP5970)60.08 (1526)29.13 (740)29.33 (745)5.32(135)3.94(100) 3.94(100) (in. (mm))Top coverFront coverPapercassette3.94(100)(in. (mm))30.71 (780)Foot PositionsThe rubber feet are 6 mm high, and dimensions of the top surface are 0.59 in. (15 mm) x 0.91 in.(23 mm) for the front feet, and 0.94 in. (24 mm) x 0.39 in. (10 mm) for the rear feet.Front Surface (in. (mm))2.48(63) 17.43(442.7) 3.99(101.3)2.48(63) 17.43(442.7) 3.99(101.3)1.56 (39.6) 16.37 (415.7) 3.53 (89.7)1.77 (45) 16.46 (418) 3.23 (82)