1 Before Using the Printer271.5 Adjusting to Paper WidthSlide the guide against the left or the right side of the paper that you want to use.1 Make sure that the main power switch is at the on position (|).If it is off, switch the main power switch to on.2 Open the feeder cover.The feeder lift tray lowers automatically. Wait for it to stop.3 Loose the screw of the guide.If the screw is tight, use a coin to loosen it.● The width of the tray is set to accept commercially available business card size(55 × 91 mm (2.17 × 3.58 in.)) for printing. To use another size, slide the guideagainst the left or the right side of the paper. If the guide cannot adjust correctly tothe paper width, the paper may not print correctly.If the paper still does not feed correctly even after you adjust the guide, you may beusing paper that requires special adjustment. Please contact the dealer where youpurchased the printer or the nearest service center.● Never touch the feeder lift tray while it is moving, and never place your hand underthe tray. This could cause personal injury or damage the printer.NoteCaution
