Canon 3433B010 Basic Manual

Also see for imagePROGRAF iPF750 MFP M40: Install guide Basic guide Brochure Basic guide User guide

Contents

Canon 3433B010 Basic Manual Manual pdf 39 page image

39Error MessagesError Message Cause Corrective ActionExecute printhead cleaning. The Printhead nozzles areclogged.Follow these steps to clean the Printhead.If this message is still displayed, replace thePrinthead.Cannot adjust printhead. The Printhead nozzles areclogged.Execute Head Posi. Adj. again, as follows.Press the OK button to clear the error.1.Print a test pattern to check the nozzles.2.Clean the Printhead if the nozzles are clogged.3.Execute Head Posi. Adj. again.4.The Printhead cannot be aligned;highly transparent film is loaded.Press the OK button to clear the error.(→"Checking for Nozzle Clogging," User Manual)(→ , If Vertical Lines are Warped or Colors areMisaligned)(→ , If Printing is Faint)(→ , If Vertical Lines are Warped or Colors areMisaligned)The Printhead is installed crooked. Straighten the Printhead as follows, and then executeHead Posi. Adj. again.Use Head Inc. Adj. to adjust the angle of inclinationof the Printhead.2.Execute Head Posi. Adj. again.3.(→"Adjusting Line Misalignment (Head Inc. Adj.),"User Manual)(→ , If Vertical Lines are Warped or Colors areMisaligned)We recommend using a type of paper that you oftenuse, other than film, for Printhead adjustment.Press the OK button to clear the error.1.Stop printing by pressing ▲ or ▼ to select StopPrinting.Clean the Printhead.2.1.(→ , If Printing is Faint)(→ , Replacing the Printhead)Press ▲ or ▼ to select Print, and then press the OKbutton to resume printing. However, note that thiserror may affect the printing quality.If OK is shown on the Display Screen, clean thePrinthead.If this message is still displayed, replace thePrinthead.Clean the Printhead.2.(→ , If Printing is Faint)(→ , Replacing the Printhead)Press the OK button on the Control Panel to stopprinting.1.