Canon 3433B010 Basic Manual

Also see for imagePROGRAF iPF750 MFP M40: Install guide Basic guide Brochure Basic guide User guide

Contents

Canon 3433B010 Basic Manual Manual pdf 28 page image

28Always check the Adj. Priority values before using Auto(GenuinePpr) or Auto(OtherPaper).•Adjustment is not possible with Auto(GenuinePpr) and Auto(OtherPaper) when using highly transparent media. Inthis case, use Manual adjustment.•If additional fine-tuning is necessary after Auto(GenuinePpr) and Auto(OtherPaper) , execute Adj. Fine Feed•This may take some time, depending on the type of paper.•Use paper of the same type and size for adjustment as you will use for printing.•Always make sure the loaded paper matches the type of paper specified. Adjustment cannot becompleted correctly unless the loaded paper matches the settings.•Use Adjust Length to ensure that lines in CAD drawings are printed at exactly the right length.•(→"Selecting a Feed Amount Adjustment Method (Feed Priority)," User Manual)(→"Manual Banding Adjustment (Image Qual. Adj.)," User Manual)(→"Fine-Tuning the Paper Feed Amount (Adj. Fine Feed)," User Manual)(→"Adjusting Line Length (Adjust Length)," User Manual)1Perform adjustment as follows.If printed images are affected by banding in different colors across the sheet, execute Adj. Quality for automaticadjustment of the paper feed amount.There are two modes of automatic adjustment to correct banding: Auto(GenuinePpr) and Auto(OtherPaper).In either mode, the printer prints and reads a band adjustment test pattern for automatic adjustment of the feedamount.Paper toPrepareRolls•An unused roll at least 10 inches wideSheets•Auto(GenuinePpr): One sheet of unused paper of at least A4/Letter sizeAuto(OtherPaper): Two sheets of unused paper of at least A4/Letter size (or one sheet when usingA2 or larger)If Banding OccursThis topic describes how to adjust the feed amount automatically.Load the paper.(→ , Attaching the Roll Holder to Rolls)(→ , Loading Rolls in the Printer)(→ , Loading Sheets in the Printer)Use this mode with paper identified in the Paper Reference Guide. (→ , Types of Manuals)Auto(OtherPaper)•Use this mode with paper not in the Paper Reference Guide, or if Auto(GenuinePpr) does not eliminatebanding.Auto(GenuinePpr)•