Canon 3433B010 Basic Manual

Also see for imagePROGRAF iPF750 MFP M40: Install guide Basic guide Brochure Basic guide User guide

Contents

Canon 3433B010 Basic Manual Manual pdf 30 page image

30Use paper of the same type and size for adjustment as you will use for printing.•Always make sure the loaded paper matches the type of paper specified. Adjustment cannot becompleted correctly unless the loaded paper matches the settings.•Always check the Adj. Priority values before using Adjust Length.•(→"Selecting a Feed Amount Adjustment Method (Feed Priority)," User Manual)If the Tab Selection screen is not displayed, press the Menu button.•12To ensure that lines in CAD drawings are printed at exactly the right length, use Adjust Length to adjust theamount that paper is advanced.Additionally, two modes are available in both AdjustmentPrint and Change Settings: A:High or B:Standard/Draft.B:Standard/Draft: This setting is applied when Standard or Draft is selected in Print Quality in the printerdriver.•A:High: This setting is applied when Highest or High is selected in Print Quality in the printer driver.•Paper toPrepareRolls•An unused roll at least 10 inches wideSheets•One sheet of unused paper of at least A4/Letter sizePerform adjustment as follows.Load the paper.On the Tab Selection screen of the Control Panel, press◄ or ► to select the Settings/Adj. tab ( ).If Line Length Does Not MatchAdjust the length of printed lines as follows.(→ , Attaching the Roll Holder to Rolls)(→ , Loading Rolls in the Printer)(→ , Loading Sheets in the Printer)There are two options in Adjust Length: AdjustmentPrint and Change Settings.Change Settings: No test pattern is printed. Instead, you will measure a document already printed todetermine the discrepancy.•AdjustmentPrint: After a test pattern is printed, you will measure the discrepancy based on the results ofprinting.•High-precision rulerHigh-precision ruler㪏㪇㩼Remaining AmountMaint. cart.ReadyOK:Setting/Adj. Menu