Canon 3433B010 Basic Manual

Also see for imagePROGRAF iPF750 MFP M40: Install guide Basic guide Brochure Basic guide User guide

Contents

Canon 3433B010 Basic Manual Manual pdf 34 page image

34Error MessagesError Message Cause Corrective ActionGARO Wxxxx (x represents anumber)There is a problem with the printjob.Try printing again, using the correct printer driver.It is also possible to continue printing in this state.However, you may not be able to obtain the desiredprinting results.GL2: Wxxxx The memory isfull.(xxxx is 0501, 0903, or 0904)The printer memory is full. Because the entire print job could not be received,the printer may not be able to print the entire original.Check the printing results.GL2: W0502 The parameter isout of range.A parameter specified in an HP-GL/2 command is out of thesupported range.Check the print job.GL2: W0504 This command isnot supported.The printer has received anunsupported HP-GL/2 command.Check the print job.No ink left. There is no ink left. Open the Ink Tank Cover and replace the Ink Tank forwhich the Ink Lamp is flashing.Ink insufficient. The ink level is low, so you cannotprint, clean the Printhead, or doother operations that require ink.Press ▲ or ▼ to select Rep. Ink Tank, and thenpress the OK button. Replace the Ink Tank that is lowwith a new Ink Tank.Not much ink is left. Not much ink is left. Prepare a new Ink Tank.We recommend replacing the Ink Tank with a new InkTank at this point if you plan to print large-format orhigh-quantity jobs.Close Ink Tank Cover The Ink Tank Cover is open. Close the Ink Tank Cover.Ink tank is empty. There is no ink left in an ink tank. Open the Ink Tank Cover and replace the Ink Tank forwhich the Ink Lamp is flashing.Unable to detect ink levelcorrectly.The remaining ink level could notbe correctly detected.Close the Ink Tank Cover.(→ , Replacing Ink Tanks)(→ , Replacing Ink Tanks)(→ , Replacing Ink Tanks)The buzzer will stop once the error is cleared.The buzzer will stop once the error is cleared.If you have specified ProcessingOption > Warning >On in the Control Panel menu, set it to Off instead.If you have specified ProcessingOption > Warning >On in the Control Panel menu, set it to Off instead.In the Control Panel menu, setting On-the-Fly toOn may enable printing. However, check the printingresults because the image may be incomplete insome cases.Press ▲ or ▼ to select Continue to print, and thenpress the OK button to resume printing. However,note that this error may affect the printing quality.