Canon 3433B010 Basic Manual

Also see for imagePROGRAF iPF750 MFP M40: Install guide Basic guide Brochure Basic guide User guide

Contents

Canon 3433B010 Basic Manual Manual pdf 15 page image

15TroubleshootingHP-GL/2 ProblemsPhenomenonHP-GL/2 printing takes a long time Please wait a while until printing is finished.Large print jobs with a lot of datatake longer to print.The printer stops when printing anHP-GL/2 job (the carriage stopsmoving)Please wait a while until printing is finished.HP-GL/2 jobs are printed inmonochrome (or color)Check the Color Mode setting in the Control Panelmenu.The printer is analyzing the printjob.The Color Mode setting in theControl Panel menu is incorrect.Lines or images are incomplete inprinted HP-GL/2 jobs.With HP-GL/2, printing ismisalignedCheck the size of the data in the print job.Check the print job and settings.Check the printing commands.The memory is full.An HP-GL/2 command notsupported by this printer wasreceived.The plotter origin is incorrect.Cause Corrective ActionLines are printed too thick or thin inHP-GL/2 print jobsCheck the Width setting value specified for Pen no.in the palette (Palette A or Palette B) selected in theControl Panel menu. If fine lines are printed faintly,setting ThickenFineLines to On will print the linesmore distinctly.The Width setting in the ControlPanel menu is incorrect.(→ , Menu Map)(→ , Menu Map)In the Control Panel, set Auto Rotate to Off andprint again.The printer has received print datathat includes HP RTL commandswhen Auto Rotate is On in theControl Panel menu.(→ , Menu Map)Replotting with HP-GL/2 jobs is notpossible.Data for replotting is lost after the followingoperations. In this case, send the print job again.The data was lost because ofreplotting.HP-GL/2 jobs are printed atmaximum size, even if a standardsize is specifiedIn MAIN MENU, set PageSizeProcess2 or ConservePaper to On.The page size of the HP-GL/2print job, as created in the sourceapplication, is incorrect. The layout will be changed to the optimal layout.(→ , Menu Map)(→ , Menu Map)However, for optimal Printhead performance, theprinter consumes trace amounts of color ink evenwhen Monochrome is selected as Color Mode.Printed colors of lines areinaccurate during HP-GL/2 printingSetting AdjustFaintLines to Off in the ControlPanel menu may help produce the expected results.However, lines in some colors may appear broken.AdjustFaintLines is On in theControl Panel menu.The memory buffer was cleared from the ControlPanel.1.The printer was turned off.2.The printer received a new HP-GL/2 print job.3.Printing has been canceled4.HP-GL/2 jobs are printed 6 mmlarger than specifiedIn the Control Panel menu, set PageSizeProcess1to On.The page size of the HP-GL/2print job, as created in the sourceapplication, is incorrect. (→ , Menu Map)Adjust the Margin setting values in the Control Panelmenu.The Margin setting in the ControlPanel menu is incorrect.In the Control Panel menu, set Input Resolution to300dpi and print again.A job was printed when InputResolution in the Control Panelmenu was set to 600dpi.(→ , Menu Map)In the Control Panel menu, set Input Resolution to300dpi and print again.A job was printed when InputResolution in the Control Panelmenu was set to 600dpi.