Campbell Hausfeld WG3060 Operating Instructions & Parts Manual

Also see for WG3000: Operating instructions & parts manual

Contents

Campbell Hausfeld WG3060 Operating Instructions & Parts Manual Manual pdf 1 page image

Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/orproperty damage! Retain instructions for future reference.IN211104AV 9/99Operating Instructions & Parts Manual Models WG3000 and WG3060Wire FeedArc WelderBUILT TO LASTTMThis line of Campbell Hausfeld wire feedwelders is designed to be used onstandard 115V household current. Thewelders are equipped with infinite wirespeed control to accurately select theproper wire feed rate needed for variouswelding conditions. Internal componentsare thermostatically protected.These welders are designed for use withFlux Core Arc Welding (Gasless) or GasMetal Arc Welding (Mig) process. Asdelivered from the factory, this weldercan weld with .024” (.6 mm) to .035”(.9 mm) diameter wire. A starter spoolof .035” (.9 mm) flux-cored wire and a.040 tip are included.UnpackingSome welder components may befound in the wire feed compartment.When unpacking, inspect carefully forany damage that may have occurredduring transit. Report any damaged ormissing items by calling (800) 746-5641.Circuit RequirementsThis equipmentrequires a dedi-cated 115 volt circuit. Refer to thefollowing chart for the correct circuitbreaker or fuse rating. Do not runother appliances, lights, or tools onthis circuit while operating thisequipment. Extension cords are notrecommended. Blown fuses and trippedcircuit breakers can result from failureto comply with this recommendation.Components and Controls1. Work Clamp - connect to workpiece.2. Wire Feed Gun with .040 tip3. Power Cord - plug into 115 voltoutlet.4. On/Off Switch5. Infinite Wire Speed Control -turns clockwise to increase wirespeed and counterclockwise todecrease wire speed.6. Heat Selector - Selects weldingpower. Four selections are possible7. Polarity Hook-up - Attach torchcable to (+) for MIG and (-) for fluxcore wire.Heat Circuit Breaker orSelector Slow Blow FuseDanger means ahazard that willcause death or serious injury if thewarning is ignored.Warning means ahazard that couldcause death or serious injury if thewarning is ignored.Caution means ahazard that maycause minor or moderate injury if thewarning is ignored. It also may mean ahazard that will only cause damage toproperty.NOTE: Note means any additionalinformation pertaining to the productor its proper usage.MODEL WG3000Low (1-2) 15 ampHigh (3-4) 20 ampQUALITYASSURANCEPROGRAMNeedAssistance?Call Us First!1-800-746-5641DescriptionMODEL WG306011223344 & 65567Figure 1General Safety© 1999 Campbell Hausfeld / Scott Fetzer For parts, product & service informationvisit www.campbellhausfeld.com7