Vehicle PersonalizationMemory SeatIf your vehicle has thisfeature, then the controlsfor the memory functionare located on thedriver’s door.These buttons are used to program and recall memorysettings for the driver’s seat, throttle and brakepedals, both the driver’s and passenger’s outside mirror,the radio station presets and the previously usedclimate control system settings. The settings for thesefeatures can be personalized for both driver 1 anddriver 2. Driver 1 or driver 2 corresponds to the memorybuttons labeled 1 and 2 on the driver’s door and thenumbers on the back of the remote keyless entrytransmitters.To store the memory settings, do the following:1. Adjust the driver’s seat (including the seatbackrecliner, lumbar, and side wing area), throttleand brake pedals, both of the outside mirrors, andthe radio station presets to your preference.2. Press and hold the 1 or 2 (for driver 1 or 2) buttonof the memory control for three seconds. A doublechime will sound to let you know that the positionhas been stored.To repeat the procedure for a second driver, follow thepreceding steps, but press the other numberedmemory control button.Each time button 1 or 2 is pressed and released whilethe vehicle is in PARK (P), a single chime will sound andthe memory position will be recalled.If you use the unlock button on the remote keyless entrytransmitter to enter your vehicle, the preset driver’sseat, throttle and brake pedal, mirror positions, radiostation presets and the last choosen climate controlsettings will be recalled if programmed to do so throughthe Driver Information Center (DIC). See DIC Operationand Displays on page 3-47. The numbers on theback of the transmitters, 1 or 2, correspond to thenumbers on the memory controls.2-47
